GCC Technologies Elite XL-20/600 User Manual page 199

Appendix G: Radio and TV interference
Your printer generates radio frequency energy and, if not installed and used in
accordance with GCC Technologies' instructions, it may cause interference to radio
and television communications.
This GCC printer was certified under test conditions that included the use of
shielded cables and connectors between system components. It is mandatory that
you use shielded cables and connectors to reduce the possibility of causing interfer-
ence to radio, television, and other electronic devices.
You can determine whether your printer is causing interference by turning it off. If
the interference stops, it was probably caused by your printer.
If your printer does cause interference to radio or television reception, you can try to
correct the interference by using one or more of the following measures:
• Turn the television or radio antenna until the interference stops.
• Move the printer to one side or the other of the television or radio.
• Move the printer farther away from the television or radio.
• Plug the printer into a different outlet so the printer and receiver are on differ-
If necessary, you should consult your dealer or a radio/television technician for
additional suggestions. You may also find helpful the following booklet prepared by
the Federal Communications Commission: How to Identify and Resolve Radio-TV
Interference Problems. This booklet is available from the US Government Printing
Office, Washington, DC 20402, Stock No. 004-000-00345-4.
ent circuits.
G-1