GCC Technologies Elite XL-20/600 User Manual page 180

Warning: If the RAM SIMM and ROM card are not correctly inserted
completely into the socket, your printer will display an error message when you turn
it on and will not operate.
If you are having trouble inserting the SIMM or ROM card:
•
•
9.
10. Warning: Do not touch the controller board while the printer is switched
11. If the printer showed the ready message, replace the side cover.
C-6
Make sure that the cards are in the correct sockets. The ROM card is shorter
than the SIMM.
Make sure that the notch in each card is toward the top.
Remove the grounding wrist strap from the printer (if necessary).
on. Turn on the printer and wait to see if the control panel shows the
"ready" message. If it does, turn the printer off and go to the next step.
If the ready message does not appear, turn off the printer. Gently try to
rock the ROM card and SIMMs. If they are inserted correctly, they should
not move. Carry out step 10 again.
If the ready message still does not appear, and you are confident that you
have installed the ROM card and SIMM correctly, call GCC technical sup-
port at 781-276-8620 (U.S. only) or your local GCC dealer or service center.
L O C
A L T
A L K
R S -
4 2 2
S C S
I
P A R
A L L
E L
10 B
A S E
-T
A A U
I