GCC Technologies Elite XL-20/600 User Manual page 181

Place the cover next to the printer so that it is about an inch (30mm) to
the rear of its installed position. Hold the top rear of the cover with one
hand and use the other to lift the cover into the groove at the top of the
cover opening. Align the three hooks on the inside lower edge of the side
cover with the three openings in the printer's frame.
Slide the cover toward the front of the printer until the front edge of the
side cover fits into the groove on the front side cover.
12. Tighten the two thumbscrews (at the rear of the side cover) by hand.
Make certain that the printer is switched off. Reinstall the interface cables.
13. Turn the printer on again. If the "ready" message appears on the control
panel, the physical installation was successful. You now have to confirm
the installation and update the printer driver on all computers that use
this printer.
Confirming the installation
These steps confirm that printer recognizes the additional memory.
1. Switch on the printer.
2. Press the On Line button on the control panel; you will see the message
"Off Line" in the display panel.
3. Press the Menu key four times; you will see "Printer Info" in the display
panel.
4. Press the Enter key; you will see the total amount of RAM that the printer
recognizes. If this is the same as the new total of RAM, press the On Line
key and the printer goes back on line.
If this figure is not the same as the total amount of RAM, turn the printer
off, and remove the side cover. Now carry on from step 10 in the previous
set of steps, beginning with the paragraph "If the ready message does not
appear . . ."
C-7