Paper Handling - GCC Technologies Elite XL-20/600 User Manual

5. Paper Handling –
Submenu
Default Source: Which paper tray is used
if the print job does not specify a paper tray.
Paper Group: The sizes and orientations of
paper that the 500-sheet paper tray handles.
Default Size: The size of paper that
applications expect to find when an application
does not specify a paper size.
Jam Recovery: After you clear a jam, the
printer reprints any pages that were inside the
printer at the time of the jam. With Jam
Recovery enabled, pages that were exiting into
the output tray will also be reprinted.
Paper Reserve: Whether the printer will
draw paper from another paper tray if the
selected paper tray is empty or has the wrong
size paper. (The reserve paper tray must
contain the same size paper.)
MPFeeder Orient: The orientation of
paper that applications expect to find in the
multipurpose feeder.
Paper Thickness: Improves print quality
when printing on heavy paper.
Manual Feed Timeout: How long the
printer will wait for paper to be put in the
multipurpose feeder after the computer has
sent a manual feed request to the printer.
press the Enter key to access the submenus.
Settings
Tray 1, Tray 2, Tray 3,
MPFeeder (MultiPurpose feeder),
or Manual Feed.
U.S. and International (220 volt
printers ship set to International).
Letter, Legal, Legal 13",
Tabloid, 13" x 18", 13" x 18.5",
13" x 20", 13" x 35", Statement,
Executive, A3, A4, B5, Postcard,
Commercial #10, Monarch, DL,
or C5.
Disabled or Enabled.
Enabled or Disabled.
Long Edge Feed or
Short Edge Feed.
Normal and Thick.
Range from 30-600 seconds (in
30-second increments), or Never
Timeout. Default is 300
seconds (5 minutes).
Notes
Only available paper trays will be shown.
If Tray 1 is selected the 20 and 35 inch sizes do
not appear.
Printing is slightly faster when Jam Recovery is
Disabled, as more of the printer's RAM is
needed to store page details.
If enabled, the printer prints from another
paper tray when the paper tray specified by the
print job is empty or has the wrong size paper. If
Disabled is selected, the printer displays a
message to load a paper tray.
This submenu only affects paper sizes that can
be loaded into the MultiPurpose feeder in either
orientation.
If you print on paper heavier than normal letter
or A4, set this submenu to thick for best results.
If you do not place paper in the feeder before
the timeout occurs, the job will not be printed.
You will have to send it again.
• 8 - 9