Create Diameter Tool And Set Teaching Area - Doosan M0609 Reference Manual

No.
10 Angle Image Display
11 Angle Tolerance Setting
12
13
The center of Line A and Line B refers to the detected line center rather the
guideline of the teaching area box.
2.4.7

Create Diameter Tool and Set Teaching Area

The Diameter Tool measures the diameter and the center point position of the measured circle. Align
the circle center with the center of the circular item, position circle A outside the circular item to be
measured, and position circle B inside the circular item. Press Calculate to measure the circle, and the
diameter and center point of the circle are displayed. Adjust the acceptance range (Tolerance) of the
check based on measured diameter values to set the diameter check.
Item
Displays the angle between lines detected in two teaching areas
on the image.
Configures the angle tolerance from the reference angle.
 If a value exceeds the Test tolerance range, the inspection
result outputs 0.
 Press the Apply button to apply the setting.
Apply Applies Vision Job settings.
Cancel Cancels Vision Job Tool settings.
Description
111