Channel Settings - LABORIE MMS Solar Blue User Manual

• Confirm stop investigation
• Use puller for profile
• Puller speed/manual pull speed
• Artefact detection
• Initial values marker
Create report immediately after the investigation
When the setting Print report is set to always or optional, the report can be
created immediately after the investigation, using the selected report
configuration defined in the protocol. To select the configuration, click the
Reporter button behind Print report or behind Save report to PDF. In the
dialog box, you can also edit the printer settings/PDF settings for the report.
The selected report configuration will be saved per protocol, per investigation
type. The printer and PDF settings will be saved globally for all protocols, but
only for the reports that will be created after the measurement. You can find
more information about the reporter program in the separate Reporter Manual
in PDF format, which you can open via the Manuals menu in the database
program.
Channels and connections
In the protocol, you must set the channels for each investigation (e.g., Pves,
Pabd, Pdet) to be measured and the connections for each channel. Use the
buttons Channels and Connections to set this information. For more
information, see § 12.5.8 and § 12.5.9.
Click the Transducer button to choose the transducers used during the
investigation. In most cases, just select standard pressure transducers. Only
change this setting when you're using user-calibrated transducers. The
Catheter button is not used for urodynamic investigations.
12.5.8

Channel settings

Click the Channels button to display the Channel settings dialog box shown
in Figure 12.15.
This dialog box provides an overview of all available channels. For each
investigation, you can set the following:
• The channels to be measured (e.g., P
• The channels to be calculated (e.g., P
• The layout of these channels (e.g., color, position, scale)
Measurement Program
, P
ves abd
, P
det clos
Solar Blue User Manual
, P , EMG)
ura
)
181