LABORIE MMS Solar Blue User Manual page 237

Message
The system is not powered. Please check the
power connection
The WPU [Name] has lost the connection
There are more channels available in the
protocol file ([Filename]) then supported by this
software version!
This color scheme is read-only
Unable to display the Clouse contour plot
Unable to display the graphs
Unable to start the investigation (MMS
perfusion pressure too high) The pressure
release valve is probably polluted. Release the
tube from the water container and try to restart
the pump. If the error remains, the system
should be sent to MMS for maintenance.
Warning: compliance marker in miction phase
Warning: No more Profile markers!
Warning: No more Profile markers!
Wireless patient module connection lost.
WPM not connected! Check the Range of the
Wireless patient module, Check the Bluetooth
dongle or replace the batteries
WPM not connected! Check the Range of the
Wireless patient module, Check the Bluetooth
dongle or replace the batteries
WPU not connected! Check the Range of the
Wireless patient unit, Check the Bluetooth
dongle or replace the batteries
WPU not connected! Check the Range of the
Wireless patient unit, Check the Bluetooth
dongle or replace the batteries
Writing of channel [Channel name] to catheter
file failed!
Software messages database
Message
Can not execute [application]
Chipcard error
Could not open combination report because
of a problem with following investigation:
[Report file] Generate report file by
Explanation of symbols
Cause
System is not powered
Communication problems
Protocol file comes from a later
version
Operator tries to change a system
color scheme
Problem displaying graphs
Problem displaying graphs
Perfusion problem
Compliance marker in miction
phase
No more profile markers available
No more profile markers available
Communication problems
Module expected but not
connected
Module expected but not
connected
Module expected but not
connected
Module expected but not
connected
Writing to catheter file failed
Cause
Application cannot be executed Contact your MMS
Chipcard could not be read
N/A
Solar Blue User Manual
Posible actions to
resolve
Connect the power
Contact your LABORIE
representative
Install correct software
version or contact your
representative
Modify a different color
scheme
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Remove marker
Remove profile marker
Remove profile marker
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Contact your LABORIE
representative
Retry calibration
Posible actions to
resolve
representative
Contact your MMS
representative
Contact your LABORIE
representative
237