Prepare the wireless puller
Figure 2.21 shows an overview of the puller parts.
Figure 2.21 Wireless puller
To mount the catheter on the puller, proceed as follows:
▪ Move the slider [7] to the catheter guide [11], until the catheter clamp [9] is
positioned close to the catheter guide [11].
▪ Move the catheter through the catheter guide [11] to secure the catheter in
position during puller operation.
▪ Place the catheter under the rubber compression piece of the spring
clamp [9].
The control panel of the wireless puller contains three
LEDs: Bluetooth [1]; Status [2]; Battery [3] indication;
and one membrane button [4] to unlock the slider.
Investigation Procedure
1
Bluetooth LED
2
Status LED
3
Battery LED
4
Unlock slider button
Solar Blue User Manual
1
Puller motor enclosure
2
DC receptacle for the power
adapter
3
Battery compartment (can be
opened by removing the screws)
4
Handle to position the puller
5
Control panel
6
Pin to mount the puller on the
carrying arm
7
Slider
8
Slider protection disk
9
Catheter clamp
10
Guider
11
Catheter guide
12
Guider protection disk
13
Lock-screws to secure the cover
of the motor enclosure
14
Lock-screw to secure the guider
Figure 2.22 Control panel
37