Nikon SMZ800N Instruction Manual page 93

9
Attach a C-POL Simple Polarizing Attachment.
Attach a simple polarizing attachment to a P-DSL32, a
P-DSF32 or a C-DS stand.
This simple polarizing attachment cannot be used with a
P-ED Plan 2X/WF.
(1) Loosen the M4 set screw for the stage plate of the
base using a hex driver (nominal designation: 2) to
remove the stage plate, and alternatively place the
base plate of the polarizer so that it fits the base.
(2) Determine the orientation of the polarizer and tighten
the stage plate fixing screw.
(3) Place the stage glass (90 mm dia.) supplied with the
polarizer attachment on the polarizer.
(4) Loosen the fixing screw of the analyzer. Insert the
analyzer into the objective end until it reaches the
limit, and tighten the fixing screw.
Directly placing the polarizer
When a polarizing attachment is used, the periphery becomes dark in the low zoom magnification range. To
reduce vignetting, remove the stage glass and directly place the polarizer.
Drop the polarizer removed from the polarizer section into the position on the base or the stand where the
diffuser was removed. Use the original stage plate supplied with the base.
The polarizer cannot be placed directly on the C-DS Dia Illumination Stand.
10
Attach a P-SXY64 XY Stage.
Attach an XY stage to a P-PS32, a P-DSL32 or a
P-DSF32 stand.
(1) Remove the fastener for the stage. Loosen the four
M4 hexagon socket head bolts for the stage using a
hex wrench (nominal designation: 3).
(2) Loosen the M4 set screw for the stage plate on the
base using a hex driver (nominal designation: 2) to
remove the stage plate.
(3) Screw the Y-stroke limit bolt supplied with the
P-SXY64 in the stage. Use a hex wrench (nominal
designation: 2.5) when tightening the M3 hexagon
socket head bolt.
(4) Attach the P-SXY64 Stage using the four screw
holes that are located under the stage plate
attachment position.
Move the upper plate of the P-SXY64 to align the
installation holes on the lower plate with the screw
holes, insert the four M6 hexagon socket head bolts
and firmly tighten them using a hex wrench (nominal
designation: 5).
Chapter 5
Assembly
Securely attach a simple polarizing attachment
plate fixing
screw
79
Glass
Fastener
Fastening bolts (x4)
Securely attaching the P-SXY64
Fixing screw
Fixing screw
Small
chamfered
corner
Stage fixing
bolts (x4)
Y-stroke limit bolt