Assembly - Nikon SMZ800N Instruction Manual

Chapter
5

Assembly

This chapter contains the system configuration diagrams and lists of the system components, and explains how to assemble
the systems.
Before starting assembling, read the appropriate notes such as
product" at the beginning of this instruction manual and "3 Installation location" in "Notes on Handling the Product" in this
instruction manual.
CAUTION When moving or carrying the system
The total mass of the microscope system may become approx. 17 kg.
When moving the assembled microscopy system, work with at least two people. Put hands in the depression at the front of the
base and the rear of both sides to lift up the system. Be very careful not to let fingers be caught when putting it down.
 Tools necessary for assembly
Tools
Hex wrench (nominal designation: 2)
Hex wrench (nominal designation: 2.5)
Hex wrench (nominal designation: 3)
Hex wrench (nominal designation: 4)
Hex wrench (nominal designation: 5)
Hex driver (nominal designation: 2)
Hex driver (nominal designation: 2)
(support pillar fit-in type)
Spanner wrench (nominal designation: 10)
CAUTION "12 Cautions on assembling and installing the
Devices that supply tools
SMZ800N, SMZ1270, SMZ1270i Zooming Body
P-SXY64 XY Stage
P-SXY64 XY Stage
C-FIDH Fiber Holder, C-PSN/C-PSCN Plain Stand
P-SXY64 XY Stage
P-DSF32 Fiber Diascopic Illumination Stand
P-PS32 Plain Stand, P-DSL32 LED Diascopic Illumination Stand,
P-DSF32 Fiber Diascopic Illumination Stand
C-FIDH Fiber Holder
59