Nikon SMZ800N Instruction Manual page 79

[P-PS32 Plain Stand,
P-DSL32 LED Diascopic Illumination Stand,
P-DSF32 Fiber Diascopic Illumination Stand]
Attach the stage plate supplied with the stand to the base.
The procedure for attaching the stage plate is the same for
all stand types.
(1) First loosen the M4 set screw for the stage plate
located at the middle front of the stand's base using
a hex driver (nominal designation: 2).
(2) Tilt the stage plate and attach it so that it fits the
base, and then tighten the fixing screw.
Note on fixing a glass stage plate in place
Do not tighten the fixing screw too much to fix the glass stage plate in place to prevent the glass from being damaged or
broken.
Sliding mechanism
There is a clearance gap of approximately 3 mm for the sliding mechanism, around the stage plate when the
stage is securely set.
[C-PSN/C-PSCN Plain Stand]
Attach the stage plate supplied with the stand to the base.
Insert the stage plate tilted toward the front, and push in
the rear side while holding the front side.
The stage plate is securely attached by the spring.
Instead of the standard stage plate, an antistatic plate
(ESD stage plate) can be attached by following the same
procedure.
 P-DSL32 LED Diascopic Illumination Stand cable connection (Connection of the power supply to
diascopic illumination)
 When not using a control box:
Connect a 12 V AC adapter to the AC adapter input terminal on the left side of the stand's base, and then connect
the power cord.
 When using a control box:
Connect the LED brightness control terminal "CTRL" on the left side of the stand's base to the connector
"LEDDIA" on the rear side of the control box. Use the CTRL cable supplied with the control box. Connect the 24 V
AC adapter to DC24V IN of the control box, and then connect the power cord.
AC adapter input terminal
INPUT
12VDC ,
3.5A
Left side of the base
Chapter 5
CTRL
CTRL
ON OFF
LED brightness control
selection switch
LED brightness control terminal
Assembly
Securely attaching the stage plate
Attaching the stage plate
Rear side of the P2-CTLB
65
Stage plate
LEDDIA
DC24V IN