Nikon SMZ800N Instruction Manual page 21

4
Focus on the sample.
Turn the focus knob on the right and left of the stand's
support pillar to move the zooming body vertically and
focus on the sample.
The figure shows the knob turning direction and the
corresponding vertical movement of the zooming body.
 Turning the knob backward: Upward movement
 Turning the knob forward: Downward movement
(See Chapter 3, "7 Focusing on the Sample.")
5
Change the magnification using the zoom knobs.
Turn the zoom knobs on the right and left of the SMZ800N
Zooming Body to change the magnification. The figure
shows the knob turning direction and the corresponding
changes in magnification.
 Turning the knob backward: Magnification increase
 Turning the knob forward: Magnification decrease
The magnification continuously changes from 1x to 8x.
Zoom magnification values are indicated on the zoom
knobs.
Click stop during image zooming
It is also possible to use click stops at
predetermined magnification positions during
image zooming.
(See Chapter 4, "1.1 SMZ800N Zooming Body.")
Notes on microscopy procedures when using other system configurations
 With a system configuration where the illuminator uses the power supply, turn the power on and then adjust the
brightness. When microscopy is finished, turn the power off.
 With a system configuration that includes a nosepiece, bring the objective to be used into the optical path.
 With a system configuration that includes a trinocular tube, set the optical path for the binocular tube to 100%.
 With a system configuration that includes a tilting trinocular tube, adjust the angle of the binocular to one suitable for
microscopy.
Chapter 2
Microscopy Procedures
7
Focusing on the sample
Zooming in/out
Upward
movement
Downward
movement
Magnification
increase
Magnification
decrease