Nikon SMZ800N Instruction Manual page 87

3
Attach a P-EFL Epi Fluorescence Attachment.
Note on device combinations
The P-EFL Epi Fluorescence Attachment cannot be used in the microscope system that includes any of the following stands:
 C−PSN/C-PSCN Plain Stand
 C-DS Dia Illumination Stand
 C-LEDS Hybrid LED Stand
Attach an epi fluorescence attachment after performing
3.1, step 3 "Attach a zooming body."
(1) Completely loosen the M4 set screw for the
illuminator at the upper front of the zooming body
using a hex wrench (nominal designation: 2).
(2) Align the positioning groove on the rear of the round
dovetail at the bottom of the epi fluorescence
attachment with the positioning pin on the rear of the
round dovetail groove at the zooming body upper
plane so that they fit, and then tighten the fixing
screw.
 HG fiber attachment
Loosen the M4 set screw for the HG fiber on the top of the
HG fiber attachment hole on the rear side of the epi
fluorescence attachment using a hex wrench (nominal
designation: 2).
Insert the emission side tip of the HG fiber to the
attachment hole until it reaches the limit and tighten the
fixing screw.
Firmly insert the source side connector to the HG fiber
attachment hole of the C-HGFI or C-HGFIE HG
Precentered Fiber Illuminator. See the instruction manual
for the light source for details.
 Filter cube attachment
Attach a filter cube to the turret inside the epi fluorescence attachment. Up to four filters can be attached.
Do not touch the surface of the filter with bare hands
Scratches or fingerprints on the filter surface will degrade microscope images. Handle the filter cube carefully.
(1) Remove the filter cube replacement hole cover on
the right side of the epi fluorescence attachment (as
viewed from the front). Push it upward to remove.
Chapter 5
Assembly
Removing the filter cube replacement cover
73
Securely attaching the epi fluorescence
attachment
Securely attaching the HG fiber