Nikon SMZ800N Instruction Manual page 86

Attachment tool
Be sure to insert the attachment tool straight along the
two grooves of the nosepiece. Check the groove positions
by referring to the figure "Nosepiece viewed from the
bottom." If the tool is inserted at an angle, the convex part
of the tool contacts the objective, resulting in scratches or
damage to the objective.
 Cable connection to P-RNI2
When a P-RNI2 Intelligent Nosepiece is attached, connect the P-RNI2 connector to the connector on the rear left
side of the SMZ1270i Zooming Body.
After attaching the nosepiece, attach objectives by following 3.1, step 6 "Attach an objective."
2
Attach a P-CI Coaxial Epi Illuminator.
Attach a coaxial epi illuminator after performing 3.1, step 3
"Attach a zooming body."
(1) First completely loosen the M4 set screw for the
illuminator at the upper front of the zooming body
using a hex wrench (nominal designation: 2).
(2) Align the positioning groove on the rear of the round
dovetail at the bottom of the coaxial epi illuminator
with the positioning pin on the rear of the round
dovetail groove at the zooming body upper plane so
that they fit, and then tighten the fixing screw.
 Fiber attachment
First loosen the M4 set screws for the fiber on the side
plane of the two fiber attachment holes on the rear side of
the coaxial epi illuminator using a hex wrench (nominal
designation: 2). Insert the fiber to the attachment hole until
it reaches the limit and then tighten the fixing screw.
Insert the other end of the fiber into the fiber attachment
holes of the C-FLED2 LED Light source for fiber
illuminator.
Refer to the instruction manual for the light source for
details.
 1/4 λ plate attachment (optional)
There are two types of 1/4 λ plates: a 1/4 λ plate for
objectives of 1x or less, and a 1/4 λ plate for 1.5x
objectives. Both types of 1/4 λ plates are screwed in the
tip of the objective when used.
After attaching the coaxial epi illuminator, continue assembly by following from 3.1, step 4 "Attach a Tube."
Chapter 5
Assembly
Securing attaching the coaxial epi illuminator
72
Groove
Nosepiece viewed from the bottom
Positioning
pin
Securely attaching the LED fiber
1/4 λ plate
Groove