Nikon SMZ800N Instruction Manual page 10

1 Do not disassemble.
Disassembling this product may result in electric
shock or malfunction. Malfunction and damage due
to disassembling or modification are unwarranted.
Do not disassemble parts other than those
described in this manual. If you experience
problems with this product, contact your nearest
Nikon representative.
2 Read the instruction manuals carefully.
To ensure safety, carefully read this manual and the
manuals for other equipment to be used with this
product. Particularly, all warnings and cautions
given at the beginning of each manual must be
observed.
Safety is a top design priority for Nikon products.
Safety is ensured as long as the user observes all
of the warnings and cautions given in the manuals,
and uses the system only for its intended purpose.
However, failure to heed the warnings and cautions
given in the manuals, subjecting the system to
shock or impact, or attempting to disassemble the
system may result in unexpected accidents and
injury.
Product with an epi-fluorescence attachment:
The light source used for epi-fluorescence microscopy
(HG Precentered Fiber Illuminator) requires special
care during handling because of its characteristics.
Be sure to refer to the manual for the light source
being used.
3 Check the input rating
For devices that use a power supply, check that the
rating of the power supplied to the device matches
the power used by the device. If the input rating
does not match, do not use the power supply and
contact your local representative. Using an
incorrect power supply may damage the device.
4 Notes on the power cord
Be sure to use the specified power cord. Use of
other power cords may result in malfunction or fire.
This product is classified as having Class I
protection against electric shock. Make sure this
product is connected to an appropriate protective
earth terminal.
See Chapter 8, "2 Performance Properties" for the
specified power cords.
● To prevent electric shock, always turn off the
power switch (Press to the "O" position.) for the
device before connecting or disconnecting the
power cord.
Safety Precautions
WARNING
5 Heat from the light source
During and immediately after a period of
illumination, the lamp and surrounding areas
(including the lamp house) are very hot when the
light source of the illuminator is a mercury lamp.
● Do not touch the lamp or surrounding areas
during or immediately after a period of
illumination. There is a risk of burn if you touch
the hot area.
● Always attach the lamp house cover when using
this product.
● Make sure the lamp and surrounding areas have
cooled sufficiently (which may take
approximately 30 minutes) before attempting to
replace the lamp.
● Do not place fabric, paper, or highly flammable
volatile materials (i.e. gasoline, petroleum
benzine, paint thinner, and alcohol) near the
lamp house during and for about thirty minutes
after a period of illumination. Because the lamp
is very hot, ignition or fire may be induced.
viii