Nikon SMZ800N Instruction Manual page 91

(6) Assembling each part of the P-EFLC.
1) Securely attach the cover to the bottom part by
tightening the four screws on the sides.
2) Securely attach the top part by tightening the
two screws on the top.
After attaching the epi fluorescence attachment, continue the assembly by following the procedure from 3.1, step 4
"Attach a tube."
4
Attach a C-FDF Flexible Double Arm Fiber Illumination Unit.
Attach a flexible double arm fiber illumination unit to a
P-PS32 Plain Stand, P-DSL32 LED Diascopic Illumination
Stand or P-DSF32 Fiber Diascopic Illumination Stand.
Attach fiber holders using the tool holes on the base to
hold the fiber. The procedure for attaching holders is the
same for all stand types.
(1) Attach a holder of the C-FIDH Fiber Holder to the
right and left rear sides of the base. Two bolt holes
are located on each side. Tighten four M5 hexagon
socket head bolts using a hex wrench (nominal
designation: 4).
(2) Insert the flexible double arm fiber tip into the ring at
the arm end, and tighten the M4 set screw for the
fiber using a hex driver (nominal designation: 2).
(3) Firmly insert the fiber source side connectors into
the fiber attachment holes on the C-FLED2 LED
Light Source.
See the instruction manual for the light source for
details.
5
Attach a C-FID2 Double Arm Fiber Illuminator.
Attach a double arm fiber illuminator to a P-PS32 Plain Stand, P-DSL32 LED Diascopic Illumination Stand, P-DSF32
Fiber Diascopic Illumination Stand, C-PSN Plain Stand or C-PSCN Compact Plain Stand.
See the instruction manual for the C-FLED2 LED Light source for fiber illuminator for details on how to attach the
illuminator.
Chapter 5
Assembly
Cover attached
Fixing bolt
Fixing
screw
77
Top part attached
P-EFLC assembly
Securely attaching the fiber holder
Securely attaching the flexible arm fiber
(complete)
Fixing bolt
Fixing
screw