Table of Contents
Advertisement
Preface
Compliance
FCC Part 68 Compliance
Connection of data communications equipment to the public telephone network is regulated by
FCC Rules and Regulations. This equipment complies with Part 68 of these regulations which
require all of the following.
All connections to the telephone network must be made using standard plugs and telephone
company provided jacks or equivalent. Connection of this equipment to party lines and coin
telephones is prohibited. A label on the back of the front panel of data communications equipment
and on the underside or rear panel of other equipment provides the FCC Registration number and
the Ringer Equivalence Number (REN) for the unit. If requested, give this information to the
telephone company.
If the unit causes harm to the telephone network, the telephone company may discontinue your
service temporarily and if possible, you will be notified in advance. If advance notice is not
practical, you will be notified as soon as possible and will be advised of your right to file a complaint
with the FCC. The telephone company may change its communication facilities, equipment,
operations and procedures where reasonably required for operation. If so, the telephone company
will notify you in writing. You must notify the telephone company before disconnecting equipment
from 1.544 Mbps digital service. All repairs or modifications to the equipment must be performed
by General DataComm. Any other repair or modification by a user voids the FCC registration and
the warranty.
Canada DOC Notification
The Canadian Department of Communications label identifies certified equipment. This
certification means that the equipment meets certain telecommunications network protective,
operational, and safety requirements. The Department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. In some cases, the company's inside wiring associated with a
single line individual service may be extended by means of a certified connector assembly
(telephone extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines, and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas. Users should not attempt to make such
connections themselves, but should contact the appropriate electric inspection authority, or
electrician, as appropriate.
Deutschland
Installations Anweisungen: Installieren Sie die Telefonleitungen nicht während eines Gewitters.
Installieren Sie die Telefonleitungen nicht in einem feuchten Raum, auβer die Dose entspricht den
Vorschriften für Feuchträume. Berühren Sie unisolierte Telefonleitungen oder Einrichtungen nicht,
auβer diese sind vom Telefonnetz getrennt. Vorsicht bei der Installierung oder Änderung von
Telefonleitungen. Achtung: Es gibt keine durch den Benutzer zu wartende Teile im Gerät. Wartung
darf nur durch qualifiziertes Personal erfolgen.
036R340-000
Issue 16
Office Connunications Manager OCM-1000/OCM-2000
Installation & Operation
Compliance
vii
Advertisement
Table of Contents
