Flat Cable I - Omron CJ Series Operation Manual

4 Installation and Wiring

4-3-2 Flat Cable I

Preparing and Mounting DCN4-TR4 Flat Connector Sockets
• Component Names
Cover
Cable confirmation slot
1
Cutting the Cable
This step is required only for extending the cable or connecting a Terminating Resistor.
Cut the cable perpendicular to its length.
To prevent short-circuits, use a sharp cutting tool such as nipper. Confirm there is no remaining
wire coming out.
2
Setting the Cable Stopper
This step is required only for extending the cable or connecting a Terminating Resistor.
For these purposes, the cable can end in the connector. Set the cable stopper in advance. Close
the cover. Secure the hooks. Press down on the cable stopper until it clicks into place.
4-20
Cable labels
(Black, blue/green, white, and red)
Black
Cable stopper
CJ-series CompoNet Master Unit Operation Manual for NJ-series CPU Unit (Cat. No. W493)
Housing