Omron CJ Series Operation Manual page 119

Flat Cable II
Attach a DCN5-BR4 Flat Connector Plug to a DCN5-TR4 Flat Connector Socket which has already
been mounted to the communications cable.
DCN5-TR4 Flat
Connector
Socket
• Mounting Procedure
Hold the Connector Plug with the side with white line facing down, and push the Connector Plug
inward until it clicks into place.
Note To remove a Connector Plug which has been attached, hold the latches on both sides of the
Connector, and pull out the Connector Plug.
Multidrop Connections
Round Cable I or II
A DCN4-TB4 Open Type Connector is attached to the communications connector of a Slave Unit or
a Repeater Unit to convert the communications connector to an M3 screw terminal block. Then the
cable wires are connected to the Connector.
Example for Round Cable I
M3 terminal block
• Mounting Procedure
(1) To mount a DCN4-TB4 Open Type Connector on the communications connector of
the Unit, orient the Open Type Connector so that the surface with the open terminals
is facing to the left, and press in the Connector until it clicks into place.
Note To remove the inserted Connector, hold the latches on both sides, and pull out the Connec-
tor.
CJ-series CompoNet Master Unit Operation Manual for NJ-series CPU Unit (Cat. No. W493)
DCN5-BR4 Flat
Connector Plug
Slave Unit
DCN4-TB4
Open Type Connector
Communications connector
Slave Unit or
Repeater Unit
4 Installation and Wiring
4
4-11