Wiring RS-232C or RS-422A/485 Cable Connectors
Soldering
Solder as described next.
1. Place a heat-shrinking tube around each wire.
2. Presolder each wire and to its connector pin.
3. Solder each wire firmly in place.
1 mm
Heat-shrinking tube
(Internal diameter: 1.5, r=10)
4. Move the heat-shrinking tube to the soldered section and shrink the tube by heating it.
Assembling Hood
Assemble the connector hood as shown below.
Connected to FG
288
Heat-shrinking tube
Aluminum foil tape
Not connected to FG
Soldering iron
Appendix G