Platform Control Indicator Panel - JLG E450AJ Operation And Safety Manual

Platform Control Indicator Panel

(See Figure 3-3., Platform Control Indicator Panel)
NOTE: The indicator lights will illuminate for approximately 1 second
when the key is positioned to the On position to act as a self test.
1.
Battery Charge Level Indicator
Indicates the state-of-charge of the battery
pack.
2. System Distress Indicator
The light indicates the JLG Control System has
detected an abnormal condition and a Diag-
nostic Trouble Code has been set in the system
memory. Refer to the Service Manual for instructions con-
cerning the trouble codes and the trouble code retrieval.
3. Drive Orientation Indicator
When the boom is swung beyond the rear
drive tires or further in either direction, the
Drive Orientation indicator will illuminate
31215012
SECTION 3 - MACHINE CONTROLS AND INDICATORS
when the drive function is selected. This is a signal for the
operator to verify that the drive control is being operated in
the proper direction (i.e. controls reversed situations).
4.
Tilt Warning Light and Alarm
This red illuminator indicates the chassis is on
a slope. If the boom is above horizontal and
100% the machine is on a slope, the tilt alarm warn-
ing light will illuminate, an alarm will sound, available func-
75%
tions are placed in Creep speed, and drive is cut out in the
50%
direction of travel. Drive in the opposite direction may be
allowed under certain conditions.
25%
0%
Tilt Angle
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR EXTENDED,
RETRACT AND LOWER TO BELOW HORIZONTAL THEN REPOSITION MACHINE SO THAT
IT IS WITHIN THE LIMITS OF THE MAXIMUM OPERATING SLOPE BEFORE EXTENDING
BOOM OR RAISING BOOM ABOVE HORIZONTAL.
Specification
3° All Markets
3-13