Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
DO NOT attempt to lift or move machine without
using proper lifting equipment (such as a forklift)
and assistance from other people. Each piece of
lifting equipment must be rated for at least 6000
lbs. to support dynamic loads that may be applied
while lifting.
Review the Power Supply section beginning on
Page 13, then prepare a permanent location for
the machine.
IMPORTANT: Make sure prepared location is
clean, flat, and reasonably level.
This is an extremely heavy machine! Serious
personal injury or death may occur if safe
lifting and moving methods are not fol-
lowed. To be safe, you will need assistance
and power lifting equipment when moving
shipping crate and removing machine from
crate. Seek assistance from a professional
rigger if you are unsure about your abili-
ties or maximum load ratings of your lifting
equipment.
-20-
To assemble machine:
1.
Move machine over its prepared location
while still inside shipping crate.
2.
Remove top and sides of shipping crate, then
place small items aside in safe location.
Note: Do not destroy shipping crate and
packaging until after Test Run.
3.
Remove (4) lag screws and flat wash-
ers
that
secure
(see Figure 10).
Machine Foot
(1 of 4)
Lag Screw and Flat
Washer (1 of 4)
Figure 10. Machine secured to shipping pallet.
4.
Use forklift (see Figure 11) to lift machine just
enough to clear pallet, then remove pallet.
Figure 11. Lifting machine with forklift example.
Model G0887 (Mfd. Since 01/19)
machine
to
pallet
Forklift Fork
Advertisement
Table of Contents
