Inventory - Grizzly G0887 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box Inventory (Figure 7)
A. Drip Trays ................................................... 2
B. Adjustable Open-End Wrench (0-30mm) ... 1
C. Hex Wrench Set (1.5–10mm) ..................... 1
D. Support Vise Guide .................................... 1
E. Work Stop ................................................... 1
F.
Tool Box...................................................... 1
G. Grease Gun ................................................ 1
H. Open-End Wrench Set (8 x 9, 10 x 12,
12 x 14, 14 x 17, 17 x 19, 21 x 23mm) ........ 1
I.
Phillips Head Screwdriver #1...................... 1
J.
Flat Head Screwdriver
K. Hex Bolts M16-2 x 75 DOG-PT .................. 4
L. Hex Nuts M16-2 .......................................... 4
M. Foot Pads ................................................... 4
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
-16-
Qty
⁄ " ........................... 1
1
4
A
D
F
H
K L
Figure 7. Box inventory.
Model G0887 (Mfd. Since 01/19)
B
C
E
G
J
I
M