Section 4: Operations; Operation Overview - Grizzly G0887 Owner's Manual

SECTION 4: OPERATIONS

Operation Overview

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-26-
manual BEFORE
To complete a typical cutting operation, the
operator does the following:
1. Examines workpiece to make sure it is suit-
able for cutting.
2. Ensures machine has correct type and
amount of coolant for workpiece material.
3. If necessary, changes blade for workpiece
material.
4.
Verifies blade is tensioned correctly.
5.
Sets up splash guards and work stop if need-
ed for operation.
6. Turns both master power switches ON, then
turns hydraulic pump ON.
7.
Securely clamps workpiece in vise using
hydraulic controls. Ensures workpiece is sta-
ble and cutting area is free of obstructions.
8.
If necessary, adjusts blade guide arm as
close to workpiece as possible.
9.
Puts on safety glasses and respirator.
10. Reconnects to power, turns blade motor ON,
and sets proper blade speed for workpiece
material.
11. Opens coolant valves and turns coolant
pump ON.
12. Raises headstock to required height for
workpiece and adjusts to desired angle.
13. Adjusts feed rate.
14. Selects auto operation mode.
15. Completes cut.
16. Once machine has stopped, turns machine
OFF then removes workpiece.
Model G0887 (Mfd. Since 01/19)