Inspecting Drive Belt - Grizzly G0887 Owner's Manual

3. Remove drain plug, empty tank, and dispose
of coolant per federal, state, and manufac-
turer requirements (see Figure 91).
Drain Plug
Figure 91. Drain plug location.
4. Remove coolant pump access panel (see
Figure 92).
Coolant Pump
Access Panel
x 4
Figure 92. Coolant pump access panel removed.
5.
Thoroughly clean reservoir and pump filter
with hot, soapy water, then rinse with clean
water. You may need to remove coolant
pump bracket screws to access pump filter.
6.
Clean and wrap drain plug threads with
Teflon tape, then install drain plug.
7.
Mix 10 gallons of coolant according to cutting
fluid manufacturer's specifications, then refill
tank with coolant.
8.
Replace chip collection drawer.
-58-

Inspecting Drive Belt

Inspect drive belt regularly for tension and wear.
Refer to Figure 93 for proper belt tension. Belt
deflection should be approximately
moderate pressure. The replacement belt can
be found in the back of this manual in the parts
breakdown.
Deflection
Figure 93. Checking belt tension.
To replace the drive belt or adjust the tension,
refer to Replacing/Tensioning Drive Belt on
Page 74.
Model G0887 (Mfd. Since 01/19)
⁄ " under
1
4
Pulley
⁄ "
1
4
Pulley