Adjusting Blade Brush - Grizzly G0887 Owner's Manual

Adjusting Blade
Brush
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
The Model G0887 has a blade brush to help keep
metal chips off the blade wheels. It will wear over
time and require re-adjustment when it no longer
makes proper contact with the blade. Eventually
the brush will require replacement. This is con-
sidered a normal wear item and is not covered by
warranty.
Item(s) Needed
Hex Wrench 4mm .............................................. 1
To adjust blade brush:
1. DISCONNECT MACHINE FROM POWER!
2. Open wheel cover by removing (4) button
head cap screws (see Figure 94).
Figure 94. Wheel cover secure screw locations
(2 of 4 shown).
Model G0887 (Mfd. Since 01/19)
3. Loosen wing nut on blade brush adjustment
bracket (see Figure 95).
4. Adjust blade brush and cover so blade
extends approximately
brush, then tighten wing nut (see Figure 95).
Hole in bracket is slotted for easy adjustment.
Blade Brush
Cover
Blade
Figure 95. Blade brush adjustment components.
Qty
⁄ " into bristles of
1
8
Blade Brush
Wing Nut
-65-