Table of Contents
Advertisement
Setting Up the Power Amplifier
ARRANGE FOR A SKILLED PERSON TO CARRY OUT THIS STEP!
s
$
$
$
$
$
$
$
$
$
$
$
NOTE
The IR receiver receives the signals from the transmitter in the
remote control and must not be covered by objects.
WARNING:
HIGH POWER AMPLIFIER WEIGHT
The 159 is very heavy and can cause serious injury if it falls.
The power amplifier should only be unpacked and set up by skilled persons
who are experienced in handling heavy loads.
Be sure to follow the separate installation manual for the
Because of the power amplifier's high weight, we recommend consulting
a structural engineer before setting it up.
ATTENTION:
HIGH OR LOW TEMPERATURES
CAN CAUSE DEVICE MALFUNCTIONS
After unpacking the device, leave it to sit in the room for a time before
connecting and switching it on.
Carefully remove the device from the packaging and place it in a suitable
location.
ATTENTION:
IMPROPER INSTALLATION
Consider the following points when choosing where to position the device:
Avoid exposure to direct sunlight as well as excessive heat, cold, moisture
and dust.
Ensure adequate ventilation. Never place the power amplifier on an enclosed
shelf.
Do not cover the slots or openings on the device, as they are needed for
ventilation.
Only place the device on level and load-bearing surfaces.
The device requires ventilation from below. This is ensured by the height of
the adjustable feet. Place it only on firm surfaces, not on high-pile carpet.
Do not operate the
159
in the bottom half of the flight case it was transported
in.
1 5 9
M O N O
P O W E R
!
159
A M P L I F I E R
1 7 | 4 6
Advertisement
Table of Contents
