Table of Contents
Advertisement
O P E R A T I O N
M A N U A L
SPEAKER CABLES
Burmester recommends using cables with a large cross-section to connect
the loudspeakers to the power amplifier. A large cross-section ensures that
you can maintain the power amplifier's damping factor for optimal control of
the loudspeakers. The best results are achieved by using original Burmester
speaker cables, which have the same electrical and tonal characteristics
as the internal wiring of Burmester loudspeakers and amplifiers.
CORRECT POLARITY
When connecting the loudspeakers, make sure that the connections have the
$
correct polarity. It is important that you make all connections in phase:
— Positive output on power amplifier (+) = positive input on loudspeaker
— Negative output on power amplifier (–) = negative input on loudspeaker
NOTE:
Connecting the two channels out of phase causes poor bass and diffuse playback.
2 6 | 4 6
ATTENTION:
The insulation on your selected speaker cable must match that of the
$
original Burmester loudspeaker cable and must have a flame rating
of at least VW-
. If in doubt, contact your dealer.
1
The cables are connected with spade lugs, which requires you to use
$
fully assembled cables.
Advertisement
Table of Contents
