Table of Contents
Advertisement
SHORT-CIRCUITING THE SPEAKER OUTPUTS
Connecting the positive and negative terminals of the speaker's binding posts while
the amplifier is on will cause a short circuit. In this event, the speaker outputs will
automatically switch off to prevent damage to the device. The front LED (1) will flash
orange. On the control panel, LED 1 in the status display (17) will light up orange.
To reset the protective function after a short circuit:
Switch off the power amplifier.
1.
2.
Check the connections to the loudspeakers.
Switch the power amplifier on again.
3.
If the error persists, please contact your dealer.
$
Even though the protection circuit will prevent damage to the power amplifier,
you should observe the following instructions to avoid a short circuit:
Switch off the power amplifier before connecting the speaker cables.
$
Connect the speaker cables to the loudspeakers first, then to the power amplifier.
$
Never connect the positive and negative terminals of the speaker's binding posts
$
to each other or to other conductive parts, e.g. the housing of the power amplifier.
1 5 9
M O N O
P O W E R
A M P L I F I E R
2 7 | 4 6
Advertisement
Table of Contents
