Table of Contents
Advertisement
The power amplifier is now in standby mode.
$
The mains switch
switch on the device using the on/off switch
Very little power is consumed in standby mode because
only the standby power supply is active.
TO DISCONNECT THE DEVICE FROM THE MAINS:
Switch off the device using the on/off switch (18).
1.
2.
Switch the mains switch (10) to O.
Configuring Auto Power Down
The device has an auto power down function. When this function
is activated, the device automatically goes into standby mode
if there is no signal for a configured amount of time.
If your power amplifiers are connected via BurSync, all connected power amplifiers
follow the settings of the BurSync master, which is the first 159 in the network.
CONFIGURING AUTO POWER DOWN
Press the auto power down button (20).
This switches the auto power down function to the next value:
$
Off › Short › Mid › Long › Off ›...
Off
Short
Mid
Long
(10)
can remain in the I position. This allows you to conveniently
NOTE:
Always switch the device off using the on/off switch
before switching the mains switch to O.
Auto power down is deactivated.
The device switches to standby mode
after 30 minutes of inactivity.
The device switches to standby mode
after 60 minutes of inactivity.
The device switches to standby mode
after 120 minutes of inactivity.
1 5 9
M O N O
P O W E R
(18)
or the remote control.
A M P L I F I E R
3 7 | 4 6
Advertisement
Table of Contents
