Hanseatic HBCO7010PA1 User Manual page 83

1. Use a jigsaw to cut a hole in the worktop
for the hob. It must have the following di-
mensions.
560 to 564
(Measurements in mm)
2. If a hob was already installed, the cut-out
section must be no larger than:
560 to max. 574 mm wide
490 to max. 494 mm deep.
574
Attach rails!
560
7
(Measurements in mm)
3. Attach adjustment strips to the left and to
the right of the worktop in order to achieve
the width of 560 mm.
4. Seal the cut surfaces with a special var-
nish, silicone sealant or cast resin to pre-
vent swelling caused by moisture.
Preparing and inserting the hob
NOTICE
Risk of breakage!
■ Do not place the hob on the glass
ceramic edge!
1. Take the hob out of the packaging.
2. Remove all protective films and adhesive
tapes.
3. Carefully place the hob (residual heat in-
dicators at the front) in the middle of the
worktop cut-out.
Thin worktop
7
Page EN-35
Installing the hob