Form A Drip Loop Connection For Cables - Extreme Networks ExtremeWireless AP460i Installation Manual

Form a Drip Loop Connection for Cables

After the cables and antennas are connected to the access point, gather each cable below the access
point, and form a drip loop connection. You do not need a drip loop if the LAN wire is already below the
access point.
Note
The drip loop prevents water from entering the access point by channeling water down and
away from the connection points. Drip loops are required to ensure proper operation of the
access point.
Figure 21: Drip loop connection
46 ExtremeWireless™ AP460i/e Access Points