Bulb Replacement; Troubleshooting - ElectrIQ eiQCH110CEILING User Manual

TROUBLESHOOTING

Fault Cause
The fan blade is jammed.
Light on, but fan
does not work
The motor is damaged.
Both light and Power cord loose
fan do not work
The fan blade is damaged.
Excessive The fan motor is not fixed
Vibration tightly.
The unit is not hung
properly on the bracket.
1. Grease filters clogged
2. Distance between the unit
Suction
performance not
good
The following shows how to reduce total environmental impact (e.g. energy use)
of the cooking process).
Install the cooker hood in a proper place where there is efficient
(1)
ventilation.
Clean the cooker hood regularly so as not to block the airway.
(2)
Remember to switch off the cooker hood light after cooking.
(3)
Remember to switch off the cooker hood after cooking.
(4)
INFORMATION FOR DISMANTLING
Do not dismantle the appliance in a way which is not shown in the user manual.
The appliance could not be dismantled by user. At the end of life, the appliance
should not be disposed of with household waste. Check with your Local Authority
or retailer for recycling advice.
and the cooking plane too
great.
14
Solution
Switch off the unit. Repair to be
carried out by qualified service
personnel only.
Plug in to the power supply again.
Switch off the unit. Repair to be
carried out by qualified service
personnel only.
Switch off the unit. Repair to be
carried out by qualified service
personnel only.
Take down the unit and check
whether the bracket is in proper
location.
1 Clean or replace grease filters.
2 Adjust the distance to between 70cm
and 80cm.