Table of Contents
Advertisement
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed at three or six months according to your cooking habit. The
installation procedure of activated carbon filter is as below.
Attention for outdoor ventilation of cooker hood: If you choose②or④ air direction,
you need to remove the filter and panel decorative strip according to steps "6" and "7"
of INSTALLATION to install and remove carbon filters.
1. Before installing or replacing the ca rbon filters, disconnect the mains power to
the unit.
2. Press the filter lock and remove the mesh filter.
3. Turn the carbon filter on both si des of the motor anti -clockwise. Replace the
carbon filters with the new carbon filters.
4. Replace the mesh filter.
5. Connect the power supply to the wall socket.
NOTE:
Make sure the filter is securely locked. Otherwise, it would loosen and cause
danger.
When activated carbon filter attached, the suction power will be lowered.
CHANGING THE LIGHTS
Before changing the lights, make sure that the appliance is turned off and unplugged.
1.
Use a screwdriver to remove the 2 screws on the lamp board. Open the terminal
box and then remove the lamp board assembly.
2.
Loosen the 4 screws on the lamp board, take down the lamp strip and replace it.
3.
Reinstall the lamp cover securely.
ILCOS D code for this lamp is: DSL-5-S-450
• LED modules –LED lamp strip
• Max wattage: 2×5 W
• Voltage range: DC 12V
• Dimensions: 450mm
O pen
Cl ose
13
Advertisement
Table of Contents
