Table of Contents
Advertisement
2.8 Installing gas bottle
Handle gas bottles with care. There is a risk of injury if the gas bottle or the bottle valve is damaged!
Install the gas bottle on the transport unit first, then make the connections.
Use inert gas, such as argon, helium or argon-helium mixture, as a shielding gas in TIG welding. Make sure that the gas
flow regulator is suitable for the gas type used. The flow rate is set according to the welding current, joint form and the
size of the electrode.
A suitable flow rate for argon is normally 5 – 15 l/min. If the gas flow is not correctly set, this will increase the risk of
defects in the weld (weld porosity). Spark ignition becomes more difficult if the gas flow is too high.
Contact your local Kemppi dealer for choosing the gas and the equipment.
a.
Gas bottle valve
b.
Flow regulation screw
c.
Connecting nut
d.
Hose connector
e.
Gas bottle contents indicator
f.
Gas flow meter
Always secure the gas bottle properly in an upright position to a special holder on the wall or on the welding equip-
ment cart. Always keep the gas bottle valve closed when not welding. If the machine will be out of use for a long
time, unscrew the pressure regulation screw.
Do not use the whole contents of the bottle.
Use a suitable shielding gas for the welding application.
Always use an approved and tested regulator and flow meter.
© Kemppi
22
MasterTig 535ACDC
Operating manual - EN
1921940 / 2140
Advertisement
Table of Contents
