Table of Contents
Advertisement
2.10 Installing gas bottle and testing gas flow
Handle gas bottles with care. There is a risk of injury if the gas bottle or the bottle valve is damaged!
Always secure the gas bottle properly in an upright position to a special holder on the wall or on the welding equip-
ment cart. Always keep the gas bottle valve closed when not welding.
- If a cart with a gas bottle rack is used, install the gas bottle on the cart first, then make the connections.
- The maximum recommended size of the gas bottle to be installed on the T22M cart is 20 liters.
- Install the welding gun to the welding device before installing and testing the gas bottle.
Contact your local Kemppi dealer for choosing the gas and the equipment.
1.
Without gas bottle cart: Place the gas bottle in a suitable, secure location.
2.
With gas bottle cart: Move the gas bottle on the transport unit's gas bottle rack and secure it in place with the straps
and fixing points provided.
3.
If not already, connect the welding gun to the welding device (refer to "Connecting welding gun" on page 17).
4.
Connect the gas hose to the welding device.
© Kemppi
29
Master M 205, 323
Operating manual - EN
1922130 / 2313
Advertisement
Table of Contents
