Table of Contents
Advertisement
3.2.9 Screen saver
The screen saver image shown during start-up and when the control panel has been idle for a predefined time can be
changed using the screen saver tool at kemp.cc/screensaver. To make the change, you'll need the image file you are
planning to use and a USB memory stick.
Tools needed:
T20
1.
On a web browser, go to kemp.cc/screensaver.
2.
Following the on-screen instructions, upload, edit and download the new screen saver image onto a USB memory
stick.
3.
Detach the control panel from the power source. Refer to "Replacing control panel" on page 24 for more inform-
ation.
Do not disconnect the control panel cable. The power source and control panel must be turned on.
4.
Connect the USB memory stick to the USB connector on the rear side of the control panel. The control panel detects
your USB memory stick automatically and shows a list of available images.
Always connect and disconnect the USB device in a straight angle to avoid any additional stress to the USB con-
nector.
5.
Following the on-screen instructions, and using the control panel controls, select the image on the USB memory
stick you want to use as a screen saver.
6.
Remove the USB memory stick and install the control panel back in place. Refer to "Replacing control panel" on
page 24 for more information.
To delete a custom screen saver image from the control panel memory, or to use the Kemppi logo instead, go to "Set-
tings view" on page 44.
© Kemppi
48
MasterTig 535ACDC
Operating manual - EN
1921940 / 2140
Advertisement
Table of Contents
