Table of Contents
Advertisement
2. INSTALLATION
Do not connect the equipment to the mains before the installation is complete.
Do not attempt to move or hang the equipment mechanically (e.g. with a hoist) from the handle on the power
source unit. The handle is meant only for manual moving when the equipment is installed on a cart.
Place the machine on a horizontal, stable and clean ground. Protect the machine from rain and direct sunshine.
Check that there is enough space for cooling air circulation in the machine vicinity.
Before installation
•
Make sure to acknowledge and follow the local and national requirements regarding installation and use of high
voltage units.
•
Check the contents of the packages and make sure the parts are not damaged.
•
Before you install the power source on site, see the requirements for the mains cable type and fuse rating given in
the "Technical data" on page 57 chapter.
Distribution network
MasterTig 535ACDC: Provided that the public low voltage short circuit power at the point of common coupling is
higher than or equal to the value stated on the list below, this equipment is compliant with IEC 61000-3-11 and IEC
61000-3-12 and can be connected to public low voltage systems. It is the responsibility of the installer or user of the
equipment to ensure, by consultation with the distribution network operator if necessary, that the system impedance
complies with the impedance restrictions.
•
MasterTig 535ACDC: 3.4 MVA
According to the EMC classification (Class A), the MasterTig equipment is not intended to be used in residential loc-
ations where the electrical power is provided by the public low-voltage supply system.
© Kemppi
7
MasterTig 535ACDC
Operating manual - EN
1921940 / 2140
Advertisement
Table of Contents
