Table of Contents
Advertisement
Problem
The extruder is off-center.
Filaments are not properly extruded
or adhering to the build plate.
The equipment does not respond
before starting printing the model.
At the end of printing, filaments are
attached to the nozzle in blocks;
Or filaments are scattered in the
printer in the form of filaments.
The model is only half printed.
The printing filament cannot be
extruded.
The extruder can not return to its
original position.
In the steep protruding part, the
surface of the model is slender and
sparse or worn.
7. Maintenance
7.1 Copy the Log
7.2 Maintenance and Service
Cause
The equipment has lost the precise
position track of the extruder and
thus leading to printing failure.
It may be that the build plate is not
leveled and the distance between
the build plate and the extruder is
inconsistent.
The equipment may have received
conflicting commands.
A layer of the model did not adhere
correctly, and the minimum surface
area in contact with the build plate
was adopted when saving the
model; Or no support is selected
when printing and it is suspended
above the build plate.
The printing filaments run out.
The extruder is blocked during
printing.
The extruder is blocked.
Limit switch line fault.
The model protrudes too far or
shakes too much.
(angle less than 45 degrees).
26
1. Insert the USB disk, and an icon
the upper right corner of the touch screen of the
equipment.
2. Click the icon
, wait for 10 seconds, and unplug
the USB disk.
3. Insert the USB disk into the computer and open the
USB disk folder to find the log file.
4. Please send the log file to Flashforge After-sales
Service.
Remove the model, clean the build
plate, return the extruder back to its
original position, and recalibrate.
Then print a new model.
Re-level.
Turn off the power switch, wait for
30 seconds, and then turn on the
power switch.
Re-slice the model and add
supports if necessary.
Replace the printing filament, turn
on the filament detection function,
and continue printing; See "The
printing filament cannot be
extruded" below for more.
Use the unclogging pin tool to push
the filament in the filament feeding
state.
Contact After-sales Service.
Contact After-sales Service.
Print with supports.
will appear in
Solution
Advertisement
Chapters
Table of Contents
