Maintenance; Suggestions On Platform Plate Usage; Suggestions On Nozzle Usage; General Maintenance - Flashforge Adventurer 5M Pro User Manual

6.1 Suggestions on Platform Plate Usage

1. Powder coated PEI plate requires glue and is suitable for printing PLA/PETG/PLA-CF/PETG-CF/
ABS/ASA. TPU printing does not require glue. This plate comes with the printer.
2. PEI film plate is suitable for printing PLA/TPU without glue. For PETG, it's recommended to use
glue. This plate can be purchased separately.
3. PC sticker platform plate is suitable for printing PC/ABS/ASA. This plate can be purchased
separately.
4. After applying glue to the platform plate, it can be cleaned with water.
5. If the platform plate gets oily, it can be cleaned with a dish detergent.
6. If the platform plate deforms significantly after long-term use, it's recommended to replace it
with a new one.

6.2 Suggestions on Nozzle Usage

1. Please use one nozzle for the same type of material to avoid clogs and extend nozzle lifespan,
especially when working with fiber-reinforced materials and PETG. Please avoid mixing them
with other materials.
2. When switching to a different material with the same nozzle, if the new material's printing
temperature is lower, adjust the setting to a higher temperature for filament extrusion to purge
old filament from the nozzle.
3. When switching to a different material with a higher printing temperature, just load the new
filament.
4. To clean residual filament inside the nozzle, you can perform multiple filament loading or
manually clear any remaining filament using the unclogging pin tool.
5. After replacing the nozzle, please perform leveling again.

6.3 General Maintenance

1. Please apply lubricating oil to the guide rails after 200 hours of printing.
2. Please replace the filter cotton every 300 hours of printing or when it appears darker in color.
3. Please clean the filament residue inside the equipment chamber in time.

6. Maintenance

29