Anti-Oozing Plate; Daily Maintenance And Use Suggestion - Flashforge Creator 3 Pro User Manual

7.5 Anti-oozing Plate

It is a normal phenomenon that the anti-oozing plate may have partial scratches on itself due to factory testing. With
the continuous use of printing, scratches will become more obvious, but this will not affect the use of the nozzles, and
the distance between the anti-oozing plate and the nozzles can be adjusted manually. Please make sure that the
nozzles are always in contact with the anti-oozing plate when in use. If the scratches are deep, it can be replaced
according to the actual situation.

7.6 Daily Maintenance and Use Suggestion

1. When the equipment is not used in daily life, please cover the top cover and close the front door to avoid dust falling
on the equipment. If the equipment is not used for a long time, it is recommended to use original package for sealing.
2. Lubricate the moving parts regularly. If the equipment is used frequently, add lubricating oil (grease) at least once
every three months; If the equipment is not used for a long time, add lubricating oil (grease) at least once every six
months.
3. After each printing, please clean up the filament residue and other sundries in the printing cavity in time to avoid
small sundries falling into the bottom circuit board and affecting the use of the equipment.
4. Printing stickers are consumables. When the adhesion of the build plate's stickers drops or even the sticks are
damaged, please replace the printing stickers in time so as not to affect the printing effect.
5. After using the equipment for the first time or replacing the printing filaments, Flashforge official filaments shall be
used until the colors of the filaments extruded from the nozzles are consistent with the colors of the filaments loaded.
6. At any time, it is recommended to place the model at the center of the build plate. You can set the placing position of
the model in the slicing software.
7. Support printing is recommended for steep protruding parts (angle less than 45 degrees).
28