Unclog The Nozzle; Replace The Nozzle Assembly - Flashforge Creator 3 Pro User Manual

1. Click [Preheat], set the heating temperature, and tap the Return button.
2. Click [Tools]-[Filament]-target extruder [Load], wait for the extruder to heat up until the screen prompts for filament
feeding, and insert the pin into the extruder inlet (top).
3. Push the blocked residue down and squeeze it out from the nozzle. If you encounter some resistance, you can push
down. Be careful not to use brute force. If you have tried doing this several times and it still can not be clogged with
force, then you need to replace the nozzle or contact after-sales customer service.
Please operate with the power off：
1. Unscrew the screws with an Allen screwdriver and
remove the extruder cover;
3. Replace the nozzle assembly with a new one. Be sure to push the nozzle assembly to the bottom, and there must be
no installation gap. Tighten the corresponding screws; Insert the wire harness into the extruder circuit board; Cover the
housing and lock the screws.

7.3 Unclog the Nozzle

7.4 Replace the Nozzle Assembly

2. Unscrew the screws here and pull out the wire harness
of the heating pipe and thermocouple;
27