Flashforge Creator 3 Pro User Manual page 2

Note: Every 3D printer has undergone printing test before leaving factory. If there are some residues in the extruder
of the equipment or some slight scratches on the build plate, it is normal and will not affect its use.
Dear Flashforge users, thank you for choosing Flashforge products. Thank you for your great support and help for
Flashforge. Please read this guide carefully before use and follow the instructions strictly. The whole Flashforge team
will provide you with superior service. No matter what problems you encounter during use, please contact us according
to the phone number and email address provided at the end of the guide.
In order for you to better experience our products, you can also acquire skills about the equipment operation from the
following sources.
(1) User Guide:
Please unpack the box carefully. Then you can take out the attached documents from the top foam or browse the latest
user guide from the USB disk. This will help you familiarize yourself with the equipment and successfully complete your
first printing.
(2) Official Flashforge Website:
Flashforge Chinese website: www.sz3dp.com
Flashforge English website: www.flashforge.com
You can visit the Flashforge official website to obtain information about related software and hardware, contact
information, equipment operation, equipment maintenance and other related information.
PLEASE STRICTLY FOLLOW ALL THE SAFETY WARNINGS AND NOTICES BELOW ALL THE TIME.
Keep Creator 3 Pro's work table clean and tidy.
Do not operate Creator 3 Pro in the presence of flammable liquids, gases or dust. (The high temperature generated
by equipment operation may react with airborne dust, liquids, and combustible gases and cause fire.)
Keep Creator 3 Pro out of children and untrained persons' reach.
Make sure to use Creator 3 Pro with a properly grounded outlet. Do not refit Creator 3 Pro's plug. (Ungrounded/im-
properly grounded/modified plug will inevitably increase the risk of electric leakage.)
Do not expose Creator 3 Pro to damp or hot-sun environment. (Humidity will increase the risk of electric leakage./Ex-
posure to sunlight will accelerate the aging of plastic parts.)
Make sure to only use the power supply provided by Flashforge.
Do not use Creator 3 Pro during an thunderstorm.
Please shut down Creator 3 Pro and unplug it if it is not in use for a long time.
Do not touch the extruder and build plate, etc during printing.
Do not touch the extruder when finishing printing.
Dress properly. Do not wear scarves, masks, gloves, jewelry ornaments or other objects that can easily get caught in
the equipment when operating it.
Do not operate Creator 3 Pro while you are tired or under the influence of drugs, alcohol or medication.
PREFACE
NOTICE
WORK ENVIRONMENT SAFETY
ELECTRICAL SAFETY
PERSONAL SAFETY
01