Standard Axle Weighing Operation - Cardinal 190 Installation, Technical And Operation Manual

IMPORTANT! The following prompt, id= (ID Prompt) is displayed after the touch=
(Key Touch Sensitivity) parameter ONLY in the Model 190A.
id= (ID Prompt)
The id= (ID=) parameter enables an ID prompt to be displayed when the PRINT key is
pressed and printed a ticket.
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it. Otherwise, use the Fn/ key to toggle to a new
setting and press the TARE  key to save it. Allowable values are:
id=Yes
ID prompt will be displayed when PRINT
key is pressed and printed on the ticket.

Standard Axle Weighing Operation

After placing the wheel load weighers on the ground in front of the steering axle, the two
weighers are connected together using the interconnection cable assembly. One weigher
(makes no difference which) is connected to the indicator using the indicator interface cable.
The interconnection diagram is shown below:
Printer
Indicator Cable
Weight
Indicator
Power
1. Power the indicator on.
2. If the weight display is not 0, press the ZERO key.
3. Have the vehicle driven onto the axle load weighers until each wheel is centered on the
respective axle load weigher.
4. The axle weight will be displayed on the indicator.
5. When the display shows that the weight is stable, press the PRINT key to record the
weight.
6. Have the vehicle driven forward until the next set of wheels are centered on the axle
load weighers.
7. Press the PRINT key to record the weight.
Wheel Load
Weigher
8400-M022-O1 Rev K  Model 190 Indicator
id=no
Normal print operation (no ID prompt)
will occur.
Interface Cable
Wheel Load
Weigher
95