Cardinal 190 Installation, Technical And Operation Manual page 74

Repeat steps 11 to 15 to set the value for the maximum acceptable weight for ID 2.
19.
Continue to enter the minimum and maximum acceptable weights for the remaining
20.
IDs for up to ten (10) IDs, or press the UNITS/◄ key at the Lo n= prompt or the Hi
n= prompt to skip the entry of the remaining weights.
Repeatedly press the TARE key to step through the remaining function prompts until
21.
the indicator returns to the weight display.
Note that if the low weight for ID 1 is set to 0, the Checkweigher function will be
22.
disabled. The low and high weights must be less than scale capacity and the high
weight must be greater than the low weight.
Target Weight Selection
From the weight display, briefly press and release the Fn/▲ key.
1.
The display will show the prompt id=.
2.
Press the TARE key.
3.
The display will show the ID of the currently selected target weight.
4.
If the setting displayed is acceptable, press the TARE key to save it.
5.
Otherwise, use the Fn/▲ key to enter a new value for the ID.
6.
When the desired value is displayed, press the TARE key to save it.
7.
The indicator will return to the weight display.
8.
Checkweigher Operation
With the Checkweigher function enabled and activated, during operation the indicator will
compare the displayed weight with the preset values and display the results as under, accept,
or over.
When the displayed weight is less than the minimum acceptable weight, the arrow over
OUT1 < (the UNDER annunciator) will turn on and the display will change to the color
selected in the section, Display Backlight Color Setup.
When the displayed weight is greater than the maximum acceptable weight, the arrow
over OUT3 > (the OVER annunciator) will turn on and the display will change to the
color selected in the section, Display Backlight Color Setup.
When the displayed weight is within the range from minimum acceptable weight to
maximum acceptable weight, the arrow over OUT2 ⊕ (the ACCEPT annunciator) will
turn on and the display will change to the color selected in the section, Display
Backlight Color Setup.
66 8400-M022-O1 Rev K  Model 190 Indicator