Operation; Standard Weighing - Cardinal 212 Series Installation, Technical And Operation Manual

3. OPERATION

3.1 Standard Weighing

Recommended Settings:
D OUT=
A-HLD=
Weighing Procedure (Gross Weight):
Weighing Procedure (Net Weight):
8200-M639-O1 Rev D 09/14
0
0
1. With the scale empty, verify the scale is showing 0 units (lb, kg, etc)
Gross (the Gross annunciator will be shown). If not in Gross mode
(the Net annunciator instead is shown), press the NET/GROSS key
to switch to Gross mode.
2. If the scale is showing a weight different than 0, press the
ZERO/CLEAR key to zero the scale.
3. The scale is now ready to receive weight. Add material to be
weighed and remove when finished.
4. Repeat these steps for subsequent weights.
1. With the scale empty, verify the scale is showing 0 units Gross. If
not in Gross mode, press the 0 key then the TARE key to clear the
stored tare weight and the indicator will display Gross weight.
2. If the scale is showing a weight different than 0, press the
ZERO/CLEAR key to zero the scale.
3. Place a tare weight on the scale (ex: an empty container) then press
the TARE key; or if you know the tare weight, you can manually
enter it by keying in the value followed by the TARE key (ex: if you
want to tare 50lbs, key in the sequence: 5, 0, TARE).
4. The scale is now ready to receive weight. You can place a filled
container on the scale or if you prefer, you can place an empty
container on the scale and watch the weight as you fill it.
5. Repeat these steps for subsequent weights. If you wish to continue
using the same stored tare weight, skip step 1.
212/212X Installation & Technical
Page 99