Accessing Setup - Cardinal 190 Installation, Technical And Operation Manual

Accessing Setup

1. With the 190 turned ON, press the Fn/ and UNITS/ key simultaneously.
2. Hold both keys until the display changes to SetUP.
3. Release the keys to begin setup.
4. Press the UNITS/ key to step to the beginning point of each setup section.
SEtUP
A-d
CAL
SetgC
Sio
Print
F SPAn
Hi rES
LoCoUt
option
fUnC
CoLors
5. If you press the TARE  key at the SetUP prompt, you may proceed through to the next
section (up to and including Colors) by pressing the TARE  key.
6. To exit setup, press the Fn/ key with any of the menu selections displayed.
NOTE: Except for the SEtUP prompt, the prompts displayed for each section are
different if you push the UNITS/ key to step through the prompts instead of
pressing the TARE  key to proceed through the section.
For example, if you press the UNITS/ key with the SEtUP displayed, the next
prompt displayed will be A-d. If you step through the setup prompts by pressing the
TARE  key, the next prompt displayed will be A-d?.
Also, at a prompt with the ? displayed, you must press the TARE  key again to
proceed with that section.
To skip the section and advance you to the next menu selection, press the TARE 
key twice.
14
See Note Below
A-d?
CAL?
SetgC?
Sio?
Print?
FSPAn?
HirES?
LCoUt?
Opt?
fUnC?
CoLor?
8400-M022-O1 Rev K  Model 190 Indicator
Setup Mode (starts at USA= prompt)
Analog to Digital Filtering (starts at dFLt= prompt)
Calibration (starts at CAL1= prompt)
Set Gravity Constant (starts at CALgC= prompt)
Serial Input/Output (starts at bAUd= prompt)
Print Tab Settings (starts at Port= prompt)
Fine Span Adjustment
Display High-Resolution Weight
Key Lockout Feature Setup
Configuration for Indicator Option Boards
Function Setup
Display Colors Setup