Cardinal 190 Installation, Technical And Operation Manual page 119

Cont2= (Continuous Output on Option Card)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and press the TARE  key to
save it.
YES = Continuous Output on Optional Serial Interface
no = No Continuous Output on Optional Serial Interface
IMPORTANT! The setting for the type= is only applied when the opt=
parameter is set to 1 and the Cont2= parameter is set to YES.
tyPE= (Continuous Output Format)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle to a new setting and press the TARE  key to save
it. Allowable settings are:
0 = Continuous Output uses SMA format
1 = Continuous Output uses Cardinal Scoreboard format
2 = Continuous Output uses Cardinal SB500 with traffic control format
NOTE: Refer to the CONT1= Continuous Output on Serial Interface, tYPE= parameter
section for a description of output formats 0 and 1.
8400-M022-O1 Rev K  Model 190 Indicator 111