Fine Span Adjustment - Cardinal 190 Installation, Technical And Operation Manual

Fine Span Adjustment

IMPORTANT! The FSPAn (FSPAn?) mode requires a load of 10% of Capacity
on the scale before adjustments can be made.
F span
Fine Span Adjustment (from SETUP Prompt)
If Fine Span Adjustment is desired, with the SETUP prompt displayed, press the
1.
UNITS/ key until the display shows the FSPAn prompt.
Place a calibrated test weight on the scale and press the TARE  key.
2.
The display will change to show the amount of the test weight, an F will be displayed to
3.
the right of the annunciators and the annunciators will alternately flash off and on.
Press the Fn/ key to increase the span by 0.5 division OR press the UNITS/ key to
4.
decrease the span by 0.5 division.
Press the TARE  key to exit the Fine Span Adjustment and advance to the
5.
Hires? prompt.
Fspan?
Fine Span Adjustment (after pressing TARE  at last Print prompt)
With fspan? displayed, press the TARE  key.
1.
The display will change to no.
2.
Place a calibrated test weight on the scale.
3.
Press the Fn/ key to toggle to yes and press the TARE  key.
4.
The display will change to show the amount of the test weight, an F will be displayed to
5.
the right of the annunciators and the annunciators will alternately flash off and on.
Press the Fn/ key to increase the span by 0.5 division OR press the UNITS/ key to
6.
decrease the span by 0.5 division.
Press the TARE  key to exit the Fine Span Adjustment and advance to the
7.
Hires? prompt.
8400-M022-O1 Rev K  Model 190 Indicator 39