Peak Hold Function - Cardinal 190 Installation, Technical And Operation Manual

Peak Hold Function

With the Peak Hold function enabled during setup of the indicator, the function must be
activated before it can be used. Refer to the section Function Setup, the FUnC (FUnC?)
parameter to enable the Fn/ key Hold function.
NOTE: Only one of the functions Hold, Count, Peak Hold, Checkweigher, or Live
Weight can be active at a time.
Activate Hold Function
Press and hold the Fn/ key until the display blanks.
1.
Once the display blanks, release the Fn/ key
2.
The display will change to show PHoldX, the prompt, and status of the Peak Hold
3.
function.
If the setting displayed is acceptable, press the TARE  key to save it. Otherwise, use
4.
the Fn/ key to toggle to a new setting and press the TARE  key to save it.
1 = Peak Hold Function Active
0 = Peak Hold Function Not Active
Repeatedly press the TARE  key to step through the remaining function prompts until
5.
the indicator returns to the weight display.
Peak Hold Function Operation
When the Peak Hold function is active, the largest weight value measured since Peak Hold
was activated (or cleared) will be stored.
To display the peak value, momentarily press the Fn/ key.
1.
To zero the peak value, make sure there is no load on the scale and press the
2.
ZERO key.
Press the NET/GROSS key to return to the weight display.
3.
64 8400-M022-O1 Rev K  Model 190 Indicator